5 Instructions for installation
IMPORTANT: Preparation and Precaution
Before beginning installation, ensure that you have sufficient clearance between
the axle and the chassis.
Use a jack if necessary
. Install at one side of the vehicle
at a time.
Pay attention to your safety at all times during installation - always use
axle
stands
to support the vehicle!
The position of the axle stands should be
under the chassis
NOT under the axle!
5.1 RECOMMENDED TIGHTENING TORQUE
During fitting of the air suspension system, it is recommended that nuts
and bolts are tightened in accordance with the following table...
THE FOLLOWING INSTRUCTIONS MAKE REFERENCE TO THE
DIAGRAMS ON PAGES 16 AND 17.
5.2 PREPARATION
1. Secure the front wheels, use wheel chocks on both sides of both front
wheels.
2. Take the ground terminal from the battery when work to electricity
is involved.
3. Lift the rear of the vehicle till there is working space of approximately
15 cm between bump stop and rear axle.
TIGHTENING TORQUE IN Nm
SIZE
CLASS 8.8
CLASS 10.9
M6 x 1.0
11.3
16.5
M8 x 1.25
27.3
40.1
M10 x 1.5
54
79
M12 x 1.75
93
137
M16 x 2.0
230
338
IMPORTANT:
• When both the bolt and nut are
made from steel use either class
8.8 or 10.9
• For all other dimensions and
tighening torques is left to the skills
of a well-trained person
9 | INSTALLATION MANUAL |
AUXILIARY AIR SUSPENSION |
NISSAN SINGLE-, KING-, DOUBLE CAB (2WD/4WD), NAVARA (4WD)
JULY 2021
