INSTRUCTION MANUAL
6
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR WINE REFRIGERATOR
•
Remove the exterior and interior packing
•
Check to be sure the following parts are included:
o
6 Slide out shelve.
o
1 Instruction manual.
•
Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Place your appliance on a floor that is strong enough to support the appliance
when it is fully loaded. To level your appliance, adjust the front legs at the bottom
of the appliance.
•
Do not place the unit to direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold or hot ambient temperatures
may also cause the appliances not to perform properly.
•
Not designed for placement in adage or basement. Designed for use inside the
home.
ELECTRICAL CONNECTION
Warning!
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK.
IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED PRODUCTS
SERVICE CENTER.
•
This unit should be properly grounded for your safety. The power cord of this unit
is equipped with a 2-pin plug which mates with 2-pin wall outlets to minimize the
possibility of electrical shock. Do not under any circumstances cut or remove the
ground wine from the power cord supplied.
•
Use of extension cords is not recommended.
•
This unit requires a standard 220V-50HZ electrical outlet with 2-pin plug.
•
The cord should be secured behind the wine refrigerator and not let exposed or
dangling to prevent accidental injury.
