CARE AND MAINTENANCE
WARNING
: Failure to unplug the appliance during
service and cleaning could result in electrical shock or
other personal injury.
REMOVING SHELVES
( DAU-32.78DB, DSS)
Pull out the shelf. Lift the wooden part and remove
from the rails.
REMOVING SHELVES
(DAU-46.146DB, DSS; DAU-52.146B, SS)
To prevent damaging the door gasket, make sure to
have the door all the way opened when pulling
shelves out of the rail compartment.
For easy access to the storage content, you must pull
the shelves approximately 1/3 out of the rail
compartment, however this unit was designed with a
notch on each side of the shelf tracks to prevent
bottles from falling.
Please refer to the following direction for replace shelf
with different method.
When removing any of these shelves out of the rail
compartment, to fit or remove the shelf, tilt the shelf
as per the diagram and simply pull out, or push in the
shelf until it sits on the support brackets securely.
REMOVING SHELVES
(DAB-42.117DB, DSS; DAB-48.125B, SS;
DX-89.246TB, TSS)
To prevent damaging the door gasket, make sure to
have the door all the way opened when pulling
shelves out of the rail compartment.
1.Fully extend the shelf you wish to remove (Fig. A)
2.Lift the front of the shelf up (Fig. A)
3.Holding the shelf track, push the shelf in, then up to
release from the rear dampers (Fig.B)
HUMIDITY CONTROL
The appliance is equipped with a system for
maintaining the correct level of humidity. Under
extremely dry environmental conditions, you may
have to add some water into the humidity box
provided with your wine cellar.
Fill the small plastic reservoir (humidity box) ¾ full
with water, and fit onto the runners found on the top
shelf of the appliance. Check the water level regularly
and refill as necessary.
Please ensure the reservoir is positioned correctly on
the runners on the top shelf to avoid the possibility of
water spillage.
ACTIVE CHARCOAL AIR FILTER
The active charcoal air filter (if your model supplied
with it) is located in the back of compartment. Replace
it with a new one once a year. It can be purchased
from your dealer or from the Spare Parts Department.
Remove the shelf in front of the filter.
•
Grip the filter and turn it 90°clockwise or
anticlockwise to remove.
•
Insert the new filter in the vertical position and
turn it 90° clockwise or anti-clockwise until it
clicks into position.