Code Rev. D 20140818 (IEC)
6
consumption.
Extreme
cold
ambient
temperatures may also cause the unit not to
perform properly.
Plug the unit into an exclusive, easily accessible
plug socket. Any questions concerning power
and/or earthing should be directed towards a
qualified electrician or an authorized products
service centre.
The appliance must be installed to all electrical,
plumbing, water and drain connections in
accordance with state and local codes.
IMPORTANT: HIGH HUMIDITY CLIMATE.
During
periods
of
high
humidity,
some
condensation may appear on outside surfaces of
glass door. This condensation will disappear
when humidity levels drop. For prevention, it is
advisable to install the appliance with sufficient
ventilation in a dry and/or an air-conditioned
place.
BUILT-UNDER INSTRUCTIONS
Make sure your installation does not block the front
ventilation grille.
The unit is designed to fit under
worktops between 820 and 890mm in height, using
the adjustable ventilation grille to ensure that the
feet are concealed from front view. Remove the
adjustable ventilation grille screws and slide it to the
required height. Tighten the screws to lock the grille
in position.
If the unit is fully integrated to be installed for fitting
kitchen plinth, make sure that the ventilation gaps in
the plinth are at least 300 square centimeters and
remove the ventilation grilles, so that warm air can
disperse unhindered. Otherwise the appliance has to
work harder, resulting in an increase in electricity
consumption.
NOTE:
When pushing the appliance into the niche,
make sure that the mains cable does not get trapped.
A
(mm)
B
(mm)
C
(mm)
D
(mm)
15cm
Wide
148
150
75
450
30cm
Wide
295
300
110
460
60cm
Wide
595
600
110
460
A (mm)
B (mm)
C (mm)
37.5cm
Wide
375
380
495
60cm
Wide
595
610
520
NOTE: The appliance must be positioned so
that the plug is accessible.
