www.usaprocom.com
21
200241-01C
9. Turn control knob counterclockwise
to the ON position. The main burner
should light.
10. Make sure the heater screen is in place
before operating heater.
11. If heater will not operate, follow the instruc-
tions
To Turn Off Gas To Appliance
, and
call your service technical or gas supplier.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: If input gas type
is NG, make sure NG pilot burner
ignites. If input gas type is LP,
make sure LP pilot burner ignites
(see Figure 35, page 25).
6. With control knob pressed in, push
down and release ignitor button. This
will light pilot. The pilot is attached
to the burner. If needed, keep press-
ing ignitor button until pilot lights.
Note: If pilot does not stay lit, refer to
Troubleshooting, pages 26 though 29.
Also contact a qualified service technician
or gas supplier for repairs. Until repairs
are made, light pilot with match. To light
pilot with match, see Manual Lighting
Procedure.
7. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
Note: If pilot goes out, repeat steps 4
through 8. This heater has a safety inter-
lock system. Wait one (1) minute before
lighting pilot again.
8. Be sure the slide switch on the front of the
receiver is in the ON position.
OPERATION
Shutting Off Heater
Turn control knob clockwise
to the
OFF position.
Shutting Off Burner Only (pilot
stays lit )
Turn control knob clockwise
to the
PILOT position.
1. Remove screen by lifting and pulling
forward.
2. Follow steps 1 through 6 under
Lighting
Instructions
, page 20.
3. With control knob in PILOT position, strike
match, and hold near pilot. Press in control
knob; pilot should light.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
5. Make sure the heater screen is in place
before operating heater.
TO TURN OFF GAS TO APPLIANCE
MANUAL LIGHTING PROCEDURE
