Service Manual for Flexible Batch Broiler, CE Version
27
6/19/2014
SM-BR-BR-0007
INSIDE VIEW
Motor
Mount
Screws
Drive Chain Deflection
CONVEYOR POsITION ADJUsTMENT
The Conveyor position is adjusted by adding
shims between the Conveyor Shaft Bearing and
the frame.
1. Remove Discharge Hood to provide visual
access to the Conveyor.
2. Adjust Conveyor height as described in the
following illustration.
3. Remove the two screws securing the bearing
to the frame.
4. Insert shims as necessary between the bearing
assembly and the frame.
5. Check Conveyor position.
NOTE:
Leading edge of Discharge Chute should
be about an 3.175 mm above the center line of
the Conveyor shaft. When correctly adjusted, the
Conveyor link should just graze the backside of
the chute. If adjusted too high, the link will roll
over the top of the leading edge of the Discharge
Chute causing a Conveyor jam.
6. If additional shims are required, repeat step
4.
NOTE:
Additional shims are located inside the
Drive Motor Cover.
7. Run Conveyor for several full revolutions to
confirm that no jamming occurs.
Discharge
Chute
Conveyor
Shaft
Position 3.175 mm
above center line of
conveyor shaft.
Conveyor Discharge shaft Adjustment
