17
Maintenance
Changing the Lamp Module
Important:
The lamp in the LCD Digital Projector contains trace amounts of
mercury. Some governments require special disposal of lamps containing
mercury. Dispose of lamps in accordance with the law and any applicable local
regulations.
The lamp module should be replaced with a certified replacement part. To
order a new lamp, contact your local dealer.
After you have changed the lamp module, make sure that you reset the lamp
counter. See “ To reset lamp hours” on page 15.
Warning:
When replacing the lamp, be sure to turn off the power and unplug
the power cord. To avoid burns, wait 30 minutes before opening the lamp
module door.
Warning:
W hen you open the lamp module door, be careful to not touch the
hot surfaces inside.
Warning:
Do not loosen or remove any screws other than those on the lamp
module door and the lamp module. Doing so may result in electric shock.
To replace the lamp module:
1. Turn off the projector and let the projector cool for at least 30 minutes.
The fan continues to run after the projector has been turned off.
2. Unplug the power cord from the projector.
3. Turn the projector upside down. With a flat head screw driver, loosen but do
not remove the slotted screw in the lamp module door.
4. Lift up on the screw side of the lamp module door. Then carefully remove
the lamp module cover.
Maintenance
Summary of Contents for ImagePro 8038
Page 1: ...LCD Projector 75 4 71 with Image Manager Feature...
Page 30: ...29...