4. Using On-Screen Menu
77
[OPTIONS(1)]
Switching the displayed image smoothly [SEAMLESS SWITCHING]
When the input connector is switched, the image displayed before switching is held to switch to
the new image without a break due to absence of a signal.
Selecting Fan Mode [FAN MODE]
[FAN MODE] is used to set the speed of the internal cooling fan.
AUTO
The built-in fans automatically run at a variable speed according to the internal temperature.
HIGH ALTITUDE
The built-in fans run at a high speed. Select this option when using the projector at altitudes ap-
proximately 5500 feet/1700 meters or higher.
NOTE:
• Set [FAN MODE] to [HIGH ALTITUDE] when using the projector at altitudes approximately 5500 feet/1700 meters or higher.
• Using the projector at altitudes approximately 5500 feet/1700 meters or higher without setting to [HIGH ALTITUDE] can cause the
projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.
• Using the projector at altitudes approximately 5500 feet/1700 meters or higher can shorten the life of optical components such
as the light module.
• Your setting will not be affected even when [RESET] is done from the menu.
Selecting Signal Format [SIGNAL SELECT]
This selects the signal to be input in the COMPUTER IN Terminal. Normally, this is set to [RGB/COM-
PONENT]. Change the setting if the color of the picture is unnatural.
RGB/COMPONENT
Automatically distinguishes RGB and component signals.
RGB
Switches to the RGB input.
COMPONENT
Switches to the component input.
Enabling or Disabling WXGA Mode [WXGA MODE]
Selecting [ON] will give priority to WXGA (1280 × 768)/WUXGA (1920 × 1200) signals in recognizing
an input signal.
When [WXGA MODE] is set to [ON], XGA (1024 × 768)/UXGA (1600 × 1200) signals may not be
recognized. In this case, select [OFF].
NOTE:
• The [ON] is selected at the time of shipment.
