6
4.3 Assembly of a table top on a stand frame,
assembly of oil tank
- Turn the table top around and screw it down to the frame by
means of screw
ø
8 x 35 mm.
When applying a frame different from that recommended by
the producer, be sure to adapt its position so as to ensure
the stability of the machine head in its tilted state.
- Oil tank (1) with assembled lever (2) insert through the bot-
tom part into the cut hole in the table top and put down as
shown in detail (D) in that way, that the edge of the tank
would fit in with the edge of the cut hole in the table top. Set
the height of the tank according to the section A-A. Tank
may not protrude out of upper surface of a table top. Nail
down the tank with nails
ø
2 x 40 mm.
- Adjust the lever (2) to the dimensions B and C.
- Insert rubber inlays (3) into the groove in a table top.
4.4 Assembly of machine head onto a stand
- Stick down rubber inlays (2) with glue into the groove in a
wedge (1) and put the wedge down on the table top (3).
- Disassemble trasported tank (cover) from the machine head
and assemble hangers (4) on the head.
- Put the head down into the rubber inlays (2) and (5).
- Define space along circumference of basic machine plate.
2 mm forwards, 1 mm backwards (head will later move
forward because of its own weight), along sides 1,5 mm up to
2 mm.
- Conforming with holes in a wedge (1) and in hangers (4) drill
holes through the table top
ø
3,5
in length approx. 30 mm in
the table top.
- Screw the wedge down to the table top with screws
ø
5 x 30
mm.
- Screw the hangers down to the table top with screws
ø
5 x
40 mm. Tighten the screws so that oscillating of the head on
rubber inlays would not be reduced.
- Insert supporting pin (6).
A - A
1
2
4
3
4
6
2
5
B
= ~82
A
A
3
3
D
1
2
C
= 9mm
D
www.promelectroavtomat.ru
Summary of Contents for 4181i
Page 38: ...13 www promelectroavtomat ru...
