Dubreq Stylophone S2, Manual

Page: 2 / 4

5. SubSubosc
6. Sa SubSubosc
7. SubSubosc
8. Sa SubSubosc
VCO2 SHAPE: waveform/shape of VCO2 and sub-oscillator toggle
(8 variations as VCO1 options above)
RINGMOD: EXOR ring modulation between the square outputs of VCO1 & VCO2
1. ring mod off (LED off)
2. ring mod on
3. ring mod on (mode 2)
4. ring mod on (mode 3)
HARDSYNC: hard synchronisation of VCO2 to VCO1
1. hardsync off
2. hardsync on (LED on)
OCTAVE UP: shifts the keyboard up one full octave per touch (LED lights on +2 max octave shift)
OCTAVE DOWN: shifts the keyboard down one full octave per touch (LED lights on -2 max octave shift)
Then top to bottom (clockwise) on the right of the speaker:
LOWPASS: low pass filter on/off (LED = on)
HIGHPASS: high pass filter on/off (LED = on)
(WEAKNOTCH: When LOW&HIGH are both off)
(BANDPASS: When LOW&HIGH are both on)
VCO1/2 PITCH TOGGLE: Switches knob 1 between tuning of VCO1(LED on) and VCO2(default). Switching
between VCO1/2 synchronises the two oscillators to the point knob1 is set. You can set one oscillator then
switch and intentionally de-tune the second. Switching again then synch's them.
LFO DEST: LFO destination
1. VCO1 & VCO2 frequency (LED on)
2. VCO1 frequency only
3. VCO1 & VCO2 frequency, VCA amplitude
4. VCO1 frequency & VCA amplitude
5. VCA only
LFO RESET: LFO reset behaviour
1. no reset (LED off)
2. reset LFO to 0 degrees on key press
3. reset LFO to 180 degrees on key press
4. reset LFO alternating between 0 and 180 degrees
LFO SHAPE: shape of LFO waveform
1. Sine
2. Triangle
3. Saw Rising
4. Saw Falling
5. Square (50%)
6. Square (duty-cycle controlled by knob#2)
7. Random
8. Staircase