2
Hardware Visuals: (hardware will be found on underside of the side desk (B))
Step 1
: Carefully lower center section
(A)
so that it is flat on its back.
Step 2:
Install
Levelers
(5) in the bottom of the center section (
A
). After installing the
Levelers
and
setting the center section (
A
) upright, it may be necessary to adjust
Levelers
to ensure proper door
alignment.
Step 3:
Attached to the underside of the desk (
B
) will be the legs (
B-‐1
and
B-‐2
) and any needed
hardware. Place leg (
B-‐1
) so that the screw holes are facing inward towards the corner bracket. Refer to
Figure A
Step 4:
Insert threaded stud on leg through corner bracket. Then place a
Washer
followed by a
Lock
Washer
followed by a
Nut
on the threaded stud outside the corner bracket. Ensure leg is secure by
tightening the
Nut
with ½” socket or wrench, but be careful to not overtighten as this could pull stud
from leg
Repeat
Steps 3
and
4
to attach the second leg (
B-‐2
)
Step 5:
Slide
Ferrules
over legs and screw in
Levelers
Figure A
Leg (B-‐1)
Corner Bracket
Screw Holes
