IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
Back -Lit Special Message Sign
1. Do not let power supply cords touch hot surfaces
2. Do not use outdoors
3. Suitable for use in Damp locations
4. Do not mount near gas or electric heaters
5. Equipment should be mounted in locations and at heights where it will not
readily be subject to tampering by unauthorized personnel.
6. The use of accessory equipment not authorized by the manufacturer may cause
an unsafe condition.
7. Do not use this equipment for other than its intended purpose.
8. Servicing of this equipment should be performed by qualified service personnel.
Installer
• SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
• SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
Caution:
Wire all line conductors of the branch circuit supply through an air gap disconnect switch that
is capable of being locked in the off (open) position and is within the light of sign of any section
of the sign that is energized. The off position of the switch is to be marked “OFF” and when the
switch is actuated vertically, the down position shall be the off position.
Install on a branch circuit protected by a maximum 20A breaker.
