WFFM350
9
CAUTION
Electronic Filter Meter
The Electronic Filter Meter (EFM) is revolutionary in that an LCD display reports
the actual gallons filtered by this system. When the gallons filtered approaches
the gallons capacity of the filter cartridge (see window on top of unit), it is near-
ing its designed filtration capacity.
EFM Code Summary
Battery and system are operational
- This only appears with the
initial set-up.
---
A new cartridge has been installed
- The code means flush the
cartridge with cold water until code disappears.
Flh
Your Electronic Metered Deluxe Faucet Mount comes complete with a Lifetime
Battery for your convenience.
Flashes 5
Times
The flush cycle is complete and “0” gallons have been filtered.
o o o
•
These filters are not water purifiers. Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before or after the system.
Systems certified for Cyst reduction may be used on disinfected waters that may
contain filterable Cysts.
•
This unit is not designed to filter sulfur (rotten egg odor). Use of carbon filters to treat
sulfur may intensify taste/odor problems.
•
Please comply with all state and local regulations regarding the installation of water
treatment devices.
•
The contaminants or other substances reduced by the water filter device are not
necessarily in your water.
8
Instructions For Use
1.
The DuPont™ Faucet Mount Filter is now ready for use.
2.
The Filter Life Monitor will begin to measure the gallons used, indicating
the exact volume of water that has passed through your filter. The back
light on the Electronic Filter Meter goes off after a few seconds of use.
Meter continues to measure water filtered.
3.
When the number of gallons shown on the meter equals the number of
gallons showing through the filter window (e.g. 200 gallons), the cartridge
is exhausted and should be replaced.
The Water Flow Selector
The Water Flow Selector allows you to choose two types of water flow from
your faucet depending on your need:
Unfiltered Water
– Set the Water Selector Switch in the horizontal position to
allow water to flow past the filter. Use this setting when you need to use hot
water or when you want to use cold unfiltered water for uses such as washing
hands.
Filtered Water
– Set the Water Selector Switch to the vertical position for a
stream of cold filtered water. Use this position for all filtered water uses, such
as drinking and cooking. Always turn water flow selector to unfiltered water
when through.
In this position, only cold water should be used (less than 100
degrees F or 38 degrees C) or you may damage the filter.
NOTE: Filtered water flow is typically less than half that of unfiltered water. Water flows through the filter media
at a controlled rate to assure contaminant reduction and improve taste.
V4.0
