STEP
5
-Optional Direct Connect
Install 1/4" Plastic Tubing for Water Supply Line from
System Head Outlet to Faucet
1
Determine the length of 1/4" Plastic Tubing
L
that will be necessary to connect the System Head Outlet to the threaded Faucet
Stem. Make sure to allow enough Plastic Tubing to prevent kinking in the line.
2
Cut the 1/4" Plastic Tubing squarely on both ends.
3
Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Outlet until it stops.
4
Gently slide the plastic Compression Nut down
G
(thread side up) over the tubing. Follow with the plastic Ferrule
J
, making sure
that the Ferrule is in the proper position with the larger opening on the bottom (going into the nut). Place the plastic Insert
I
into
the end of the 1/4" Plastic Tubing.
5
Firmly push the 1/4" Plastic Tubing into the end of the threaded Faucet Stem. Hand-tighten the plastic Compression Nut onto the
threads. Tighten with an adjustable wrench approximately 1/2 turn.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting. Do not over tighten the Compression Nut.
STEP
6
-Optional Direct Connect
Install the QuickTwist
™
Filter
1
Hold the QuickTwist
™
Filter
B
with the label facing to the left slightly. The two nozzles on top of the QuickTwist
™
Filter should be
toward the back of the QuickTwist
™
Filter. If holding properly, the two extended flanges on top of the QuickTwist
™
Filter should be
out to each side. See Figure 6
1
at right.
2
Lift the QuickTwist
™
Filter straight up into the System Head
A
until the two nozzles seat into the ports and the two extended flanges
on top of the QuickTwist
™
Filter are fully engaged into the System Head.
3
Turn the QuickTwist
™
Filter counter-clockwise until it stops.
X
X
WFQT130005
6
1
2
3
A
B
X
X
WFQT130005
5
X
X
WFQT130005
4
5
G
J
I
FAUCET FOR
FILTERED WATER
3
1/4" PLASTIC TUBING
INLET
OUTLET
WFCH2 Series
18
V4.0
IM WFCH2 V40 P :WFCH1_inst 8/13/09 1:47 PM Page 19
