Installation Instructions: (Create Threads)
If your truck did not come with the factory divider as shown in picture 6 follow these
steps to create the threads in the top holes of the factory seat brackets so you can use
the supplied knobs to install your DU-HA.
Using a 10mm socket and a drill or impact driver take the supplied M6-1.0 metric bolt (G)
and drive it in and out of the top holes of the factory seat brackets. The bolt is a self-
threading bolt that will create the threads needed so you can use the knobs to secure your
DU-HA in your truck. Once you have created the threads make sure the knob will thread
in and out of the holes. If it seems tight you can run the bolt in and out of the holes again.
Be careful not to cross thread if you do run the bolt in and out again, start bolt by hand.
Once you have verified the knobs thread properly, return to the previous page to step 3 to
continue the installation of your DU-HA.
Some models of trucks have a vinyl floor and do not have the factory divider. To install
the DU-HA in this type of truck set the DU-HA under the rear seat and position it so the
slots are facing the back of the truck and line up with the larger middle hole and slot in the
seat brackets. Next use the provided M6 knobs, M6 washers and M6 nuts to secure the
DU-HA to the seat brackets.
2015 - 2019 Ford F-150 SuperCab &
2017 - 2019 Ford F-250 to F-550 Super Duty SuperCab
Underseat Storage
Installation Instructions
DU-HA, Inc.
//
website: www.du-ha.com
//
phone: 1.866.306.DUHA (3842)
//
fax: 1.218.998.4013
//
306 Saint Andrews Street South, Fergus Falls, MN 56537
Rev-C
6
7
8
Fits DU-HA Part Numbers
20206
20207
20208
20209
6
7
7
DIVIDER – 20106
38
20106
20107
20108
20109
