DTS DTS-6D, Installation And Operation Manual, Page: 29 / 72

23
EXTERNAL CABLE ASSEMBLIES
•
6-Track Analog Audio Output Cable for DTS-6D - 2503-0014-00
(same part as logic cbl)
This cable connects the 6 channel DTS-6D output to an analog cinema processor.
•
6-Track Digital Audio Output Cable for DTS-6D - D713
This cable connects the 6 channel DTS-6D output to a digital cinema processor.
•
Automation (logic) Cable for DTS-6D - 2503-0014-00
(same part as analog output cbl)
This cable connects the DTS-6D logic circuitry to the cinema processor.
•
SMART Interface Cables
The following DTS cables connect the 6 channel DTS analog output to
SMART
cinema processors. The
SMART
processor does not use any DTS external breakout boards. For the Mod V, use the DTS D714 cable. For the Mod
VI, use the DTS D706 cable.
•
Timecode Cable Assembly - D435
This cable connects the DTS Timecode Reader Head to the DTS-6D Processor. On single projector (platter)
systems, this cable has a single connector at both ends. For dual (change-over) projector systems, this cable has a
single connector at one end and two connectors at the other end. See D477 for assembly diagram.
EXTERNAL BREAK-OUT BOARDS
•
Logic Break-out Boards
These boards are used to pulse to the cinema processor to the correct playback format. The analog default is
automatic or can be hard-wired forced to SR or A-type.
* D716 is used with the Dolby CP45
* D565 is used with the Dolby CP55
* D564 is used with the Dolby CP65
* D567 and one D711 cable are used with the Dolby CP200, CP100, CP50
* D715 is used with the Dolby CP500. D715 contains programming jumpers that must be set correctly.
* D571 is used with UltraStereo
•
Audio Break-out Boards
These boards are used to connect DTS 6-track outputs to an analog cinema processor/speaker amp.
* D574 is used with the Dolby CP45 and CP65
* D572 is used with the Dolby CP55
D572 contains a programming jumper, set for
MONO SURR
or
STEREO
surround
* Two D712 cables are used with the DTS D567 board (
mentioned above
) for the Dolby CP200, CP100, CP50
D567 RevB or lower, contains three programming jumpers, set all -3- for either
DRY
(standard configuration) position or
MONO SURR
(SR-D
TM
application) position.
* D575 is used with UltraStereo
* The CP500 does not use an audio break-out board.
* D725 (dual input) is used with CP65 and audio dubber