Installation
ANTENNA FLEX TX (Transmitter):
1)Plug the stadard antenna to the rear panel.
2)Link the DMX source to the DMX input socket on the frontal panel.
3)Connect power to the unit either via the Main AC power input (90 to 250 VAC) or the DC power
input (12 VDC).
To add receivers
Note: You can add receivers at any time, even during operation.
1)Power on the receiver units and ensure that they are not linked with any other transmitter (LINK
green light must be OFF)
2)Press and release the FUNCTION button on the transmitter unit
The transmitter will scan for all unlinked receives for a period of 10 seconds (LINK green light will
flash rapidly).
3)If succesfull, the receiver’s LINK green light will goes solid ON.
To unlink all receivers
1)On the transmitter, press and hold the FUNCTION button untill the LINK green light will flash
rapidly. All registered receiver will be unlinked.
ANTENNA FLEX RX (Receiver):
1)Plug the stadard antenna to the rear panel.
2)Link the ANTENNA DMX output to the projector’s DMX input connector.
3)Connect power to the unit either via the Main AC power input (90 to 250 VAC) or the DC power
input (12 VDC)
To link with a transmitter
1)Ensure that the receiver is not linked with any other transmitter (LINK green light must be OFF)
2)Press and release the FUNCTION button on the transmitter unit
The transmitter will scan for all unlinked receives for a period of 10 seconds (LINK green light will
flash rapidly).
3)If succesfull, the receiver’s LINK green light will goes solid ON.
To unlink from a transmitter
1)On the receiver, press and hold the FUNCTION button untill the LINK green light will goes OFF.
DC Power in (12 VDC)
Phoenix gold connector
Left: Ground
Right +12 V DC
DMX OUT BYPASS
(XLR female 3-5 pins)
AC Power input
(90-250 VAC)
DMX IN (XLR male 3-5 pins)
2dbi antenna
Summary of Contents for ANTENNA DMX FLEX TRX
Page 7: ...Notes...
