1. Installation
Start with antenna connection. Next
plug EASYRX card into RADIO-marked connector located on
the control board (4 pins). To EASY232 controller plug
EASYRX868 card in the direction of regulatory potentiometers.
To EASY231 controller plug EASYRX868 card in the direction of
low-voltage connectors.
2. Programming
2.1. Remote registering
Receiver has three identically programmed A, B and C
channels analogue to OPEN A, OPEN B and OPEN C inputs in
gate controller.
To register any button to first channel:
4
push and hold channelA button;
4
while holding channel A button press choosen remote
button;
4
channelA LED blink - registering completed;
4
release channelA button.
To register to second B and third C channel proceed in the same
way as for first channel using correct buttons.
Caution!
4
registering another button does not erase previously
registered button;
4
attempt of registering into memory 201 transmitter will
fail. LED will not blink.
2.2.
Easy remote registering
Easy remote registering function allows registering
new remotes without access to receiver button.
Previously registered remote is needed.
a) press and hold for 15 seconds previously registered
remote button, relase button;
b) in no more than 3 seconds press and hold new
remote button for 15 seconds;
c) new remote is registerd with the same active button
as in the previously registered remote.
Caution!
Failure in registering may be caused by low batteries, radio interferences or full memory of the receiver.
2.2.1. Easy remote registering function LOCK /UNLOCK
To protect receiver against unauthorized attempts of registering remote (important in access protected user zones)
easy remote registering function must be locked.
To lock/unlock easy remote registering function press simultaneously A and B buttons on the card. Then release one
button. LEDs A and B will light up alternately every 4 seconds. To lock/unlock easy remote registering release second button
when:
4
LEDA - easy remote registering lock;
4
LED B - easy remote registering unlock.
Fig.2
Installing EasyRX 868 card into EASY gate controller.
Fig.3
Remote button programming.
Fig.4
Easy remote registering.
PRESS ANY BUTTON OF
"OLD" REMOTE FOR 15
SECONDS
BREAK TIME
MAX 3 SECONDS
TIME
1
1
2
PRESS ANY BUTTON OF
"NEW" REMOTE FOR 15
SECONDS
2
1
1
+
PRESS ANY BUTTON
OF "NEW" REMOTE
PRESS AND HOLD
A, B or C BUTTON
spó
ł
ka z ograniczon
ą
odpowiedzialno
ś
ci
ą
spó
ł
ka komandytowa
