Connector Configuration
9
3.4
JP11, JP12 - PRIMARY/SECONDARY IDE
CONNECTORS
These connectors support the provided IDE hard disk ribbon cable. After
connecting the single end to the board, connect the two plugs on the other end to
your hard disk or other device.
3.5
JP13 - HDD LED
JP13 is usually connected to a HDD LED on front of the system case. If the HDD is
in operation, the indicator lights during operation.
Fig. 6 HDD LED
3.6
JP14 - POWER ON/OFF SWITCH
It is used to switch on or off the ATX power supply. The power is turned on by
short the power switch once. It needs to hold the power switch about 4 seconds to
turn it off when it has not start to display.
3.7
JP15 - POWER LED
Attach the power led cable to this connector. If the system is power on, the indicator
lights.
Fig. 7 Power LED
3.8
JP16 - RESET
Attach the Reset switch cable to this connector. The Reset switch restarts the
system.
