DTE Lux E, Instruction Manual

Page: 7 / 16

5
unit into the charge device, the yellow indicator will enlightened, when
charge finish, the green indicator will enlightened and the yellow one
will off. The green light is the power indicator of the charging finish. If a
battery error is detected, the indicator of the charge device will wink.
6.7 When operating finish, please clean the optical fiber with calico to
avoid infecting the light intensity.
6.8 This equipment will turn off automatically if don't any action within
2 minutes, turn it on by press any button.
6.9 The effective light intensity of this equipment is much more higher
than Halogen Lamp, The solidified depth of the curing light composites
resin for 10 seconds will not less than 4mm.
6.10 This equipment has the function of light intensity measuring.
Connect the Adapter of the light intensity measure device correctly,
aim the top of optical fiber at the sensor, turn on the main unit to emit
blue light, the green indicator of the light intensity measure device will
indicate the value of the light intensity.
6.11 The optical fiber should be sterilized for 4 minutes with 134
℃
and
2.0bar~2.3bar (0.20MPa~0.23MPa) before each use.
6.12 The curing light is equipped with over-heat protection system. It can
continuously work 200s, For example, continuously operate the curing
light for 10 times under 20s working mode (even the curing light works
less than 20s, it is counted as a full operation), then it will come into
over-heat protection status. And only after 2-minute sleep, it can restart
working 200s continuously.
7. Light intensity measurement
7.1 Connect the output plug of power adapter to the plug of DC5.0V in
the pedestal.
7.2 Choose general mode and aim the optical fiber at the measurement
point, press on / off button, the present light intensity is displayed on the
indicator of pedestal.