16
PROGRAMMING THE COLLAR
If your current collar unit is not responding to the
transmitter, it may also need to be reprogrammed
to the transmitter.
1. Hold the Transmitter Magnet Indicator (red dot)
directly against the Magnetic Activation Switch (small
bump) on the side of the Collar Unit.
2. The SmartLED light inside the Collar Unit will light
up solid for about 1 second, followed by 6 flashes.
You must keep the Transmitter next to the Collar Unit
during this time.
3. Continue to hold the Transmitter against the
Collar Unit until the SmartLED light stays on solid.
The Collar Unit is now in the
Code Running Mode
(the SmartLED light will stay lit for approximately 8
seconds while it is in this mode).
4. Remove the Transmitter from the Collar Unit and
press the ‘N’ and ‘C’ buttons (front two buttons)
simultaneously while it is in the
Code Running Mode
.
5. When the SmartLED blinks 3 times, the Collar ID
is programmed and the Collar Unit is now ON.
NOTE – Do not move the Transmitter Magnet Indicator
from the Collar Unit Magnetic Activation Switch until
after the SmartLED stops flashing and stays on solid
or the Collar Unit will not go into the Code Running
Mode. You must press the ‘N’ and ‘C’ buttons
simultaneously while the SmartLED is lit solid.