7
Federal Communication Commission Interference
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• I
ncrease the separation between the equipment and receiver.
• C
onnect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.
USING THE MOBILE TABLET
Peripherals Support
Through its USB ports, the DT311Y/ 311Q supports a wide range of USB-based
peripherals. These peripherals are applicable for software installation, applications
storage, data storage, and system software recovery and updates.
6
To Hold the Tablet
Left hand: grip the left back side of the tablet
with your left hand four index fingers, with
thumb resting on the top of the back side of the
tablet and palm securely against the back.
Right hand: grip the right back side of the tablet
with your right hand four index fingers, with
thumb resting on the top of the back side of the
tablet and palm securely against the back.
Replacing the Battery Pack
1. Slide the battery latch to the unlocked
position.
2. Lift the battery pack off the
compartment.
3. Fit another battery pack into place.
4. Slide the latch to the locked position.
5. If you want to purchase extra battery
packs, please contact your dealers, or
visit our Support page:
https://www.dtresearch.com/en/
Support/contact.html
CAUTION:
There is danger of explosion if the battery is incorrectly replaced. Replace the
battery only with the Tablet manufacturer’s battery. Discard used batteries
according to the dealer’s instructions.
CAUTION:
Do not attempt to disassemble the battery pack.
For More Support
Users can download the Tablet Modules Basic Operation Guides from the DT Research
website.
If the DT311Y/ 311Q comes with a Mobile broadband module, please contact your
product and/or service provider for the SIM Card installation procedures.
1
4
1
2
3
