The device has been tested for use against the body with 0mm separation in Specific Absorption Rate (SAR) testing.
User must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier
Trade Name:
,
Model No.: DT300Q11
Responsible Party – U.S. Contact Information
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131
http://www.dtresearch.com
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC ID Label is in battery compartment, it could be easily found by removing the battery cover.
RF Exposure Information(RED)
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum
separation distance of 0cm must be maintained between the user’s body and the handset, including the antenna.
The band 5150-5350 MHz for this device are restricted to indoor use only within all European Union countries.
Hereby, [DT Research, Inc.] declares that the radio equipment type [DT300QY01] is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131 http://www.dtresearch.com
Copyright © 2020, DT Research, Inc. All Rights Reserved.
7
