*
Fire-fighting/public addressing system
Series PC10
8
(B)
Address setting
There is a set of PC10 system to allow the multiple link of this equipment. In order for distinguishing, it is
necessary to set different addresses for any equipment. The address of the equipment makes use of 4 binary
codes “0” and “1” for setting. By means of the address setting, it is possible to connect 16 PC1011PII
equipments in a set of system in a parallel manner. The setting method is described as follows.
Prior to power-on, press down the button “+” for control of the total volume “VOLUME”, and then turn
on the power until the interface as shown in figure (2) is displayed on the screen, in which the 4 digits refer to
the address of the equipment.
1)
When setting the address, the address of the first
equipment in the same type is set to 0000, the
address of the second is set to 0001 and so on. If
there is only one local machine in a set of the
system, its address is set to 0000. Please refer to the
“
address table
”
attached for the corresponding
relationship between the address sequence of the
equipment and the binary values.
2)
The “+”keys of the eight volume control buttons
MIC1-MIC4 on the panel are used to adjust the
address digits to “1”, and the “
－
” keys are used to
adjust the address digits to “0”.Taking figure (3) as
the example, the two keys of MIC1 are used to
adjust the first digit; the two keys of MIC2 are used
to adjust the second digit, and so on.
3)
After completing the setting of the address, press
the key “
－
” of total volume control button
“VOLUME” to confirm and exit the setting
interface.
Figure (3) Example for address setting mode
MIC1 MIC2 MIC3 MIC4
+
+
+
+
Figure (1) buttons for
address setting
Figure (2) interface
for address setting
MIC1 MIC2 MIC3 MIC4
+
+
+
+
Set Address
0 1
1
0
0 1
Set Address
1
0
