Document:
RE-1D4 TCC5EU
Document:
RE-1D4 TCC5EU
Update:
April 2014
Update:
April 2014
Page:
2
Page:
2
OWNER'S MANUAL
RE-TCC5EU Color Analog camera
objective seat and rotate the knurled knob so as to move or allow the lens to the CCD. E
'sufficient to reach an approximate focus because the objective also has a focus adjustment. At
this point it is possible to refine the vision by turning the focus adjustment of the lens.
Programming Menu
The camera is equipped with a programming menu screen for advanced features. To control the
on-screen menus, operate the buttons on the rear of the camera.
In addition, the camera has a UTC chip that allows to control the
acting from the opposite end of the video cable programming menu
(DVR side) using the remote control RE-UTC must be ordered
separately.
Press the button in the center between the arrows to display the
on-screen menu.
To move around the menu, use the arrow keys and press the center button to the ENTER
function •
function •
•
LENS
- it is necessary to indicate here
LENS
- it is necessary to indicate here
camera which type of lens is being used so that the same can properly control
•
MANUAL: fixed iris lens. The camera will use the electronic iris.
•
AUTO: Auto iris lens. E 'can choose the type of Auto Iris: DC drive or Video drive.
With the lens autoris MODE option is set to AUTO and you can select the speed of the
diaphragm (or 255 ...)
SHUTTER / AGC
- in this section
SHUTTER / AGC
- in this section
sets the
operation of the electronic iris and AGC (automatic gain control). E 'can choose AUTO mode
(recommended) or MANUAL.
AUTOMATIC SETUP (CAR)
AUTOMATIC SETUP (CAR)
It has the ability to regulate the operation in HIGH LUMINANCE (daylight shooting) and
LOW LUMINANCE (night shooting). In high brightness you can choose between two
options: AUTO IRIS (for use with auto iris lens) or SHUT + AUTO IRIS (for use with
Fixed lenses). The voice BRIGHTNESS adjusts the image brightness (0 to 255). In the low
brightness section turns on or off the AGC (automatic gain control) and with the voice
BRIGHTNESS adjusts the brightness (from x0,25 to x1). The AGC brings increased
brightness of
dark images, but also introduces video noise, so you can decide whether to use it or not.
SETTING MANUAL (MANUAL) In MANUAL it is possible to manually adjust the values of
SETTING MANUAL (MANUAL) In MANUAL it is possible to manually adjust the values of
pleasure SHUTTER (iris speed - values from 1/50 to 1/10000) and AGC (from 6:00 to
44.80).
PICT ADJUST
- in this menu you can
PICT ADJUST
- in this menu you can
adjust all the parameters related to the image. The items on which
can
Act
I'm
MIRROR
(Function
mirror / image reversed)), CONTRAST (contrast), SHARPNESS (definition), defog (fog function).
WHITE BAL -
in this section there are the options for white balance, an important feature to
WHITE BAL -
in this section there are the options for white balance, an important feature to
WHITE BAL -
in this section there are the options for white balance, an important feature to
make the white color of the image that always in all types of
lighting. Are available
options:
PUSH LOCK, ATW (Auto-Tracking), PUSH, USER1, USER2, ANTI CR, MANUAL. As a rule the
ATW setting is always advisable as the white balance is automatically adjusted to vary the type of
lighting. In MANUAL options, USER1, USER2 adjusting the shades of white manually when
shooting under special lighting conditions. In option ATW is possible to set different functional
parameters including SPEED (0 to 255), DELAY CNT (0 to 255), ATW FRAME (from x0,50 to
x2,00), ENVIRONMENT (outdoor, indoor). And 'it recommended to keep the factory settings ATW
and simply choose the type of recovery Outdoor (OUTDOOR) or internal (INDOOR).
WDR
- Wide Dynamic Range; to enable for filming
WDR
- Wide Dynamic Range; to enable for filming
in backlit conditions or where they are part of other more enlightened image.
NR - (NOISE REDUCTION)
It is a video noise reduction function. Thanks to this feature,
NR - (NOISE REDUCTION)
It is a video noise reduction function. Thanks to this feature,
especially useful with little brightness, it cleans the video signal from the noise and you get a
greater uniformity of color.
HLC / BLC -
in this section you can enable and disable the backlight BLC (useful in case of
HLC / BLC -
in this section you can enable and disable the backlight BLC (useful in case of
recovery of compensation functions dark against bright backgrounds) and HLC (suitable for night
shots of vehicles with headlights on without the risk of glare in the image.
DAY / NIGHT
- allows you to adjust the threshold
DAY / NIGHT
- allows you to adjust the threshold
brightness at which occurs the switching from color to B / W for night vision. E 'can set the
camera so as to provide image always in color, always in B / W or color to automatically switch to
B / N on the basis of the light. In the latter case it is possible to set the thresholds of passage and
a possible delay.
E-Zoom -
digital zoom settings.
E-Zoom -
digital zoom settings.
DIS - PRIVACY -
This feature allows you to set masking areas to make non-visible areas
DIS - PRIVACY -
This feature allows you to set masking areas to make non-visible areas
that you want to exclude from monitoring for the need to protect privacy. When activating this
function opens a menu screen that is used to set the size and appearance of privacy masks.
You can set up to 15 privacy masks.
MOTION DET -
the camera detects any
MOTION DET -
the camera detects any
variations
resulting image
to
an intrusion.
(MOTION
DETECT / detection
of
movement). CAUTION - The motion detection is present in the chipset options, but has no real
application in the camera as this is not provided with an alarm output.
SYNC -
not used.
SYNC -
not used.