DS JB.lab T2, Operation Manual

Page: 4 / 40

ENGLISH
04 EN
INSTALLATION
8. Slide the unit into the sleeve until it locks into place.
9. To further secure the unit, use the supplied metal strap to secure
the back of the unit in place. Use the supplied hardware (Hex
Nut (M5mm) and Spring Washer) to attach one end of the strap
to the mounting bolt on the back of the unit. If necessary, bend
the metal strap to fit your vehicle’s mounting area. Then use the
supplied hardware (Tapping Screw and Plain Washer) to attach
the other end of metal strap to a solid metal part of the vehicle
under the dashboard. This strap also helps ensure proper elec-
trical grounding of the unit.
- to install the short threading terminal of the mounting bolt
to the back of the unit and the other long threadingterminal
to the dashboard.
10. Reconnect the cable to the vehicle battery’s negative (-) ter
minal. Then replace the outer trim ring and install the unit’s
front panel (see the steps of “to install the front panel”).
REMOVING THE UNIT
1. Make sure the ignition is turned off, then disconnect the cable
from the vehicle battery’s negative (-) terminal.
2. Remove the metal strap attached the back of the unit (if at
tached).
3. Press the release button to remove the front panel.
4. Lift the top of the outer trim ring then pull it out to remove it.
5. Insert both of the supplied keys into the slots at the middle left
and right sides of the unit, then pull the unit out of the dash-
board.
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow these
mounting instructions. Use the screw holes marked
T (Toyota), N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio mounting
brackets supplied with your vehicle.
(1) Metal Strap (2) Mounting Bolt (3) Hex unt (4) Spring Washer
(5) Tapping Screw (6) Plain Washer
Side View shwing
Screw Holes marked
T, N
Screw
Factory Radio
Mounting Bracket
Screw
Dashboard or Console