DS Audio DS 002 Instruction Manual Download Page 4

4

1

5

9

8

7

6

3

1. Clean the cabinet, panel, and controls with a soft cloth slightly moistened with a mild detergent solution. 

  Do not use any type of abrasive pad, scouring powder, or solvent such as alcohol or benzine.

 

2. Operational temperature should be 20degreeC to 26degree C. Warming up is recommended in winter time.
3. This optical cartridge is Amplitude proportional signal read out. It required our designated equalizer. 

  Outputs from the equalizer should be connected to CD / AUX terminals of your amplifier. Do not connect 

  to Phono terminals.

Precautions

“Output pin connection”

Red   :  Upper left  /  Right Channel (+)

Green   : Bottom left /  Right Channel (-)

White  :  Upper right  /  Left channel (+)

Blue   :  Bottom right /  Left channel (-)

Stylus Replacement

Stylus replacement is available at DS-Audio. Please consult our authorized dealer 

for its cost and time.

Power indicator LED

LED indicates power being on when it is lit. When Equalizer is turned on, yet LED 

is not lite,check the Cartridge connection and Equalizer connection
Cantilever / Stylus 

Adjust the Stylus pressure carefully as to the recommended pressure range. 

Output pins

Connect Output pins as described in “Output pin connection”.

Equalizer & Optical Cartridge

 

Descriptions of Parts and Controls

Power Switch

L / R channel lines of your turn table player are connected to those terminals. 

Make sure that each channel is connected to the same channel, while  Optical 

cartridge is taking power out from those lines, Misconnection may damage the cartridge.

  

Power On / Off button

AC Power Input

GND

INPUT

AC power cable is connected to the AC Power Source

Connect ground line of your turn table player

RCA output ( Line out )

Connect to your AUX terminal of your pre/main amplifier.

Do not connect MM/MC cartridge to this Equalizer. It may break MM/MC cartridge.

There are three sets of output.Each output provides different low frequency cut off 

     level.Please use prefeerred out put level.

OUT PUT1 ( Single cut-off ) 

OUT PUT2 ( Double cut-off )

 

Cut-off frequency:below 30Hz by 6dB/oct

Cut-off frequency1:below 50Hz by 6dB/oct.Cut-off frequency2:below 30Hz by 6dB/oct  

3

5

4

2

1

9

7

4

3

6

R

L

RED

GREEN

Blue

White

8

Summary of Contents for DS 002








Reviews: