DryFlow Recessed Hand Dryer Panel
5
P.02
P.03
Mounting instructions
The aperture required in the wall
to mount the 2470 unit is 458mm
(H) x 318mm (W) x 105mm (D), see
Illustration 1. The distance from finished
floor level to the bottom of the aperture
should be as follows:-
• Male washrooms
1028mm
• Female washrooms
978mm
• Disabled washrooms
876mm
• Children aged 14-17
978mm
• Children aged 11-13
876mm
• Children aged 8-10
774mm
• Children aged 4-7
672mm
To install the 2470 unit please follow
the steps below and outlined in
Illustration 2:
1.
Create an aperture in the wall to
the dimensions outlined in the
Mounting Instructions
(Page 2).
2.
Unattach the fascia of the 2470
unit by unclicking the back of the
2 hinges positioned in the right
hand side of the back box.
3.
Unscrew the cover of the hand dryer
and the unit itself and take out of
the back box.
Wiring instructions
Always ensure that the installation
conforms to the current edition of
the I.E.E. wiring regulations, BS 7671
(UK) or the appropriate standards in
your country. Ensure that the unit is
separately fused with a suitably rated
fuse and that it is connected to the
supply with a double pole isolating
switch having a contact separation of
at least 3mm. Care should be taken
that single insulated conductors
cannot come into contact with the
mounting surface.
4.
Offer the back box into the aperture
in the wall and fix it in place
through the holes on the side and
back of the back box.
5.
Locate the hand dryer unit into the
back box and connect the wiring to
the unit as outlined in the
Wiring
Instruction
s (Page 2). Reattach the
fascia by re-clicking the hinges back
in to position.
6.
Close the fascia panel and using the
2450K key provided, lock the panel
closed via the lock positioned in
the hand dryer chute.
1
2
318
458
WARNING
The hand dryer MUST be isolated from the power
supply during installation or maintenance.
IMPORTANT
After installation or servicing, units must be checked,
and only left when electrically and mechanically safe.