Druck DPI 800, Instruction Manual

Page: 13 / 270

Copyright 2003 Baker Hughes Company.
English–DPI 800/802 Instruction Manual | 9
1.8 Edit Functions
Example 1) Set up a label for x:y Scaling = %
To select and set up a tare value for the measurement task (a specified value
or the reading on the display).
The instrument subtracts a positive tare value, and adds a negative tare
value.
Additional data: Select Settings (

)
To select and set up a scale of values: One local scale for each
measurement task (Maximum: 5).
Additional data (Example 1/2): Select Settings (

)
To select and set up the filter values to give a smoother output for the
measurement task:
Band as a % of full scale (FS). The filter compares each new value with
the previous value. If the new value is outside the band, it is not filtered.
Low pass filter time constant in seconds. Increase the value to increase
the damping factor.
Additional data: Select Settings (

)
To select and set up the alarm values for the measurement task (maximum
and minimum).
Additional data: Select Settings (

)
Leak Test only. To set an applicable period for the leak test
(Hours:Minutes:Seconds).
Settings
x:y
1 Edit 2 Edit 3
 



Sk1 = Edit
Figure A3 - item
[26]
Edit ... Edit 4 5
%_



Figure A3 - item
[26]
Table 4: Menu Options - Settings
Options
(If applicable) Description
Sk1
=
=
123ABC
mA
+04.000
+20.000
+04.000
+20.000
OK Shift BS
_
2 3 4 5 6 7 8 9 0
Q W E R T Y U I O P
A S D F G H J K L
Z X V B N M C
1
Shift
MENU
OK
OK Shift BS
_
_ + . % ^ & * / \
q w e r t y u i o p
a s d f g h j k l
z x v b n m c
-
OK
MENU
OK