20
The pump has been designed and built in a way to require minimum maintenance.
In order to simplify maintenance, we recommend installing it in a position that is easy to reach.
The machine does not require special tools for any check and/or maintenance operations.
It is recommended to use suitable equipment and personal protective equipment
(gloves and eye protection) that are in good condition in accordance with applicable
regulations to avoid damage to people or parts of the machine.
For good maintenance, the following is important:
immediately check the causes of any faults (excessive noise, overheating, etc.),
pay particular attention to the safety devices,
use all the documentation provided by the manufacturer (operating manual, electrical diagrams, etc.),
use only tools suitable for the job and original replacement parts.
In the event of doubts and/or irresolvable problems, do not search for the fault by disassembling parts of the machine, but
rather contact the DropsA S.p.A. Technical Office.
7.2 Maintenance operations table
DANGER
To carry out all maintenance operations, wear adequate personal protective equipment, namely gloves and
eye protection, and ensure that there are no other operators in the vicinity.
The following table shows all the periodic operations required to maintain the pump in perfect operating condition.
TYPE OF OPERATION
FREQUENCY
INTERVAL
OPERATOR QUALIFICATION
Piping joints check
periodic
General cleaning of the pump
periodic
Cleaning the filling filter
2,000 h
Replacing pumping elements
As needed
7.2.1 Piping joints check
Periodically check the joints of the lines for any leaks.
7.2.2 General cleaning of the pump
Always keep the pump clean in order to quickly detect any leaks or defects.
The pump must be cleaned to remove dirt deposits.
Proceed using a dry cloth.
Take care not to damage the elements of the pump applying excess pressure with the cloth.
Do not use liquids or substances other than those indicated.
