Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Next, go to the SDK tab, shown in Figure 128. Select the “Enable API Control” box
(Note, on some versions of the DJI software it is very hard to tell if this is selected or not, so
try toggling it to select the on state). Configure the Baud Rate to 115200. Set the “Remote
Controller Channel Data to 1Hz. The rest of the settings should be configured to “Do Not
Send” as shown in the figure.
Restart the Matrice 600 to apply these changes.
9.4 DJI Onboard SDK Activation
Finally, the Matrice 600 needs to perform another activation in order to be able to forward
messages from Ignis to the Android app. This procedure needs to be performed once with
each vehicle that will be used to carry Ignis.
Power Ignis on and connect it to the Matrice 600, and turn the Matrice 600 on. Setup
Ignis via Bluetooth in the app, and read the status on the right side of the screen.
If it says No OnboardSDK Activation Result, or doesn’t show the Drone Protocol Version,
double check that the drone is on and Ignis is connected to it.
If the Matrice 600 has not performed the Onboard SDK activation, you will see an error
as in Figure 129. You’ll see this error on drones you haven’t used with Ignis before, or since
their last firmware update.
Figure 129: Error message displayed when the Matrice 600 has not performed the DJI
Onboard SDK Activation with Ignis
Last Updated March 12, 2020
Page 137
