Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Figure 115: Install slipper block in bearing tracks with magnets up. Install top plate with
the small end of the teardrop slots towards the magnets
8.3.3 Replacing A Needle
If a needle is broken or bent and needs to be replaced, you will need to remove the needle
assembly to replace the needle. Unscrew the four screws that clamp the needle retainer over
the needle, then remove the broken needle.
Figure 116: Slide the retainer over the new needle.
Slide the retainer over the new needle, as shown in Figure 116.
Last Updated March 12, 2020
Page 129
