Seat Height Adjustment
correct
Incorrect
Turn the seat lock knob anticlockwise to release
the seat post. Readjust the seat to the required
height. Replace the Seat Lock Knob and turn
clockwise to tighten, as shown above.
Ensure the Seat Lock Knob fully goes through the
seat post and the end of the Knob can be seen
protruding through the other side (ringed above).
Ensure the seat points forward as shown in the
diagram.
Seat lock
Handle Height Adjustment
To adjust the handle height, release the lock tab
on the collar and adjust the handle to the desired
height. Push the lock tab back to tighten.
To Fold the Tiller
To fold the tiller down, pull the bottom lock lever
away from the knee walker until the lock is
disengaged. While holding the lock lever in the
down position, fold the tiller down until it rests on
the seat.
Using the Hand Brake
•
Do not use the Knee Walker if the brake system
is not working properly.
•
The Knee Walker’s brake is similar to a bicycle
brake and also has a locking feature.
•
To use the brake, simply pull the lever with your
finger tips toward the handle bar.
•
To lock the brake, pull the brake lever towards
the handle bar and push down the spring
loaded push button (located on top of the brake
unit). When done correctly, the push button will
remain down and the brake lever will be locked
in place. Repeat for the other brake.
•
To release the brake, simply pull the lever
towards the handle bar. The push pin will
release up automatically.
Adjusting the Hand Brake
•
For minor adjustment, the brake adjuster
located on the handbrake can be turned out
from the hand brake anticlockwise to tighten the
brake, or clockwise to loosen the brake.
•
If further adjustment is required, apply the same
method of adjustment at the lower cable
adjuster.
•
As you adjust the cable adjuster and the
adjuster nut away from each other the brakes
will tighten, and as you adjust them closer the
brake will loosen.
