14
1
a. Push from the stopper side to take away the upper
controller. (Figure 1)
b. Use an Allen key to tight the bracket on the
wheelchair handle tube. (Choose the size of the rub-
ber pad according to the tube size). (Figure 3)
c. Put the controller holder back. (Figure 4)
d. Connect the cable form the controller into the Trig-
ger part. (Figure 5)
Install both brackets on the bottom horizontal tubing
of the wheelchair, using an Allen Key. (Figure 6)
Attach the two sections of Velcro together.
Ensure that the screws are sufficiently tight and do
not rotate on the tubing.
Feed the telescopic bar through the front end of the
PS-HA. Loosen the tristar knob on the bar and adjust
to the correct length.
Tighten the knobs on the bar and at the front of PS-
HA.
Place the two ends of the bar on the rear of the Bra-
ckets, then push the powerpack forward until it locks
in position. (Figure 7).
Place the battery pack in to the battery tray as shown
in the photograph. Secure the battery pack on its tray.
(Figure 8).
Connect the cable from the powerpack in to the un-
derneath of the handset.
Place the top loop of the lift-up strap around the op-
posite push handle to the handset. (Figure 9).
2
3
4
7
8
9
5
6
Installation Instructions
Handle set Installation
Bracket Installation
Powerpack Installation
Battery Pack Installation
Final Connection
