assembly
1. Open frame by pulling right and left side apart and
pushing down on the cross brace until fully extended.
2. Install right and left rear wheels by pushing the quick
release button (located in the center of the wheel)
on the axles and sliding it into the axle sleeve (A) until
it locks. To remove, push the quick release button and
pull out from axle sleeve.
3. Raise right and left back canes (B) until it clicks into
place.
4. Determine width of chair, 16” 18” or 20”. Remove
screws (circled below) and adjust cross brace
accordingly by pulling/pushing right and left side of
frame. Use 6mm allen wrench.
5. Loosen the rigidizer bar (C) by turning yellow knob
(D). Depress push pin (E) and adjust width accordingly.
B
A
C
E
E
D
6. Reinstall screws from step 4.
