background image

1.  Inspect all parts for shipping damage before  
  assembly.  If there is shipping damage - DO  
  NOT USE.  Contact dealer/carrier for further  
 instructions.
2.  Make certain that the U-Clips full protrude through    
  the same respective holes of each leg extension.  
  This will ensure that the leg extensions are securely    
  locked in position and an even height is achieved.
3.  Ensure ALL screws, nuts and/or bolts are  
 tightened.
4.  Check the rubber tips on the leg extensions  
  for rips, wear or if they are missing.   
  Immediately replace any or all if any of these  
  imperfections exist.
5.  All four leg extensions with rubber tips MUST  
  touch the floor simultaneously at all times.
6.  DO NOT stand on chair.

additional precautions

NOTE:

 To maintain the beauty of the original finish, 

clean with mild soap and rinse with warm water. Wipe 
bath seat dry after each use.

lifetime limited

warranty

Your Drive branded product is warrantied to be free 

of defects in materials and workmanship for the 

lifetime of the product for the original consumer 

purchaser.

This device was built to exacting standards and 

carefully inspected prior to shipment. This Lifetime 

Limited Warranty is an expression of our confidence 

in the materials and workmanship of our products 

and our assurance to the consumer of years of 

dependable service. 

This warranty does not cover device failure due to 

owner misuse or negligence, or normal wear and tear. 

The warranty does not extend to non- durable compo-

nents, such as rubber accessories, casters, and grips, 

which are subject to normal wear and need periodic 

replacement.

If you have a question about your Drive device or

this warranty, please contact an authorized Drive

dealer.

© 2018 Medical Depot, Inc. All rights reserved.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050  USA  Made in China

adjusting leg height

1.  To adjust leg height, remove U-Clip adjustment 
  hole, set leg to desired height and return U-clip  
  into adjustment hole. Make sure U-Clip clicks into  
  place.  Repeat for remaining legs. 

NOTE:

 

Make sure all legs are set to the same height.

2.  To be sure legs are locked into place, push down or  
  pull up on legs.

Summary of Contents for 12021KD-1

Page 1: ...al com deluxe bariatric shower chair with back item 12021KD 1 www drivemedical com EU Authorized Representative Drive Medical LTD Ainley s Industrial Estate Elland West Yorkshire United Kingdom HX5 9JP Rev 7 1 26 18 ...

Page 2: ...cing upwards b Take the leg receiver labeled 1 L1 and place it into the groove labeled 1 in the seat with the leg receiver holes pointing upwards c Take the leg receiver labeled 2 L2 and place it into the groove labeled 2 in the seat with the leg receiver holes pointing upwards d Insert screw A into the center screw hole through both leg receivers but do not fully tighten the screw e Secure Leg Re...

Page 3: ... each of the screw holes and secure the L shaped tube to the backrest using 2 screws C for each tube e Insert the backrest assembly tubes into the back rest receiver on the underside of the seat f Secure the backrest assembly to the seat using 2 U shaped clips G 5 Assemble legs a Insert a leg M into each of the leg receivers b Adjust each leg to the same height and align the height adjustment hole...

Page 4: ...e lifetime of the product for the original consumer purchaser This device was built to exacting standards and carefully inspected prior to shipment This Lifetime Limited Warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the consumer of years of dependable service This warranty does not cover device failure due to owner misuse or negli...

Reviews: