safety precautions
Apply the following precautions before use:
!
Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO NOT
USE. Contact your dealer for further instructions.
!
Ensure that all four ‘E’ clips are fully installed on the
traverse arms.
!
Check all four corners of the swivel bather are
resting on the top edge of the bath by at least 5cm
(2”). Check that the setscrews are lightly touching
the inside of the bath. Do not overtighten the
setscrews.
!
Always sit in the centre of the swivel bather, and do
not lean on the edges of the bather as this can
cause instability. DO NOT stand on the bather.
!
Do not exceed the weight limit of 160kg (25 st).
assembly instructions
operation
safety precautions
safety precautions
contents
‘E’ Clips x 4
Traverse Arms x 2
Swivel Seat Unit x 1
1. Insert the traverse arms in the base
plate until the required hole is seen in the
base plate.
2. Insert the ‘E’ clips into each of the
traverse arm tubing to secure.
3. Repeat the process for the other
arm, ensuring all four ‘E’-clips are used
4. Adjust the setscrews so they lightly
touch the edge of the bath.
Lift the lever arrowed, and swivel the
seat around until it locks in position and
is facing the user.
The user should sit on the seat and then
lift the lever and swivel the seat whilst
lifting their legs to they can use the bath.
