The Ai Plus is a powerful, intelligent home ventilation system that will change
fan speed, heating elements and air valves according to environmental
conditions. The same unit will suit any house size and control a full range of
features all through the initial Drivaire installer setup. Addition features can
be added at a later date still using the same base system. The system has
been designed to be “set and forget” and will carry on doing its job happily in
the background keeping your home healthy!
•
To
turn
your
system
ON/OFF
To turn ON press and hold
for 2 seconds
To turn OFF press and hold
for 2 seconds
In standard “positive pressure” mode the unit will now display
“Air ON”
Your home will be ventilated with any solar heated air in this mode.
•
To turn on supplemental
HEAT
(if heater fitted)
Press
SET
button and release
Arrow up or down through the power levels, when at the desired power level
release the button then press
SET
again to store the setting
Note: Power levels are stated in percentage of heating power 25%, 50%,
75%, Max (i.e. if 75% is selected and 2kW heater is fitted, the output will be
1.5kW)
To set the room thermostat setting – press and hold the
SET
button until
“
Room Heat Off
” is displayed. Arrow up or down to the desired temperature
setting and release the button then press
SET
again to store the setting.
•
To
set
Heat Transfer
(if transfer valve fitted)
Press and hold the
SET
button until “
Set Warm Tfr
” is displayed. Arrow up or
down to the desired temperature setting and release the button then press
SET
again to store the setting. The heat will start to transfer when the
temperature at the source rises to this setpoint.
This will set the temperature that the air valve will change and move air
from the Woodburner or Heatpump to the remote parts of the house.
•
To
select
Cool Transfer
(if transfer valve fitted)
Press and hold
MODE
button until
“Cool Tfr”
is displayed.
To set
Cool Transfer
Press and hold the
SET
button until “
Set Cool Tfr
” is displayed. Arrow
up or down to the desired temperature setting and release the button
then press
SET
again to store the setting. The cool air will start to
transfer when the temperature at the source lowers to this setpoint.
This will set the temperature that the air valve will change and move air
from the Heatpump (when in cooling mode) to the remote parts of the
house.
•
To
Select
Fresh Air
(if fresh air valves fitted)
Press and hold
MODE
button until
“FreshAir”
is displayed.
To set
Fresh Air
Press and hold the
SET
button until “
FreshAir Off
” is displayed. Arrow
up or down to the desired temperature setting and release the button
then press
SET
again to store the setting. The system will change back
to positive pressure mode (bringing air from your roof space) when the
temperature lowers to this setpoint.
•
To return to
Auto Warm
(normal mode)
Press and hold
MODE
button until
“AutoWarm”
is displayed.
