5
www.drinkstuff.com
INSTALLATION INSTRUCTIONS
This refrigerator is designed for free-standing installation only, and
should not be recessed or built-in
o
There should be left at least 200 cm³ for ventilation
o
Allow 13cm of space between the back and sides of the
refrigerator, which allows the proper air circulation to cool the
heat sink. Failure to do so could result in fire.
o
The bottom should allow at least 50mm for air flow, this
surface must not be heated
o
The entire cooling system should be considered in the
ventilation
Place your refrigerator on a surface that is strong enough to support it
when it is fully loaded
Locate the refrigerator away from direct sunlight and sources of heat
(radiator, heater, stove, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption
Extreme cold ambient temperatures may also cause the unit not to
perform properly
Avoid locating the unit in moist areas
Plug the refrigerator into an exclusive, properly installed-grounded wall
outlet. Do not under any circumstances cut or remove the third (ground)
prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician.
After plugging the refrigerator in to a wall outlet, allow the unit to cool
down for 2-3 hours before placing
Additional Installation Instructions for
DS28917 and DS28918
These units use thermoelectric refrigeration technology (no compressor)
and is not designed for storage in hot areas like garages, warehouses or
outdoors since it is designed to operate at a maximum of 17°C below the
ambient temperature
