Drinkpod 1000 Pro Series, Installation Manual

Page: 25 / 67

Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series
2-23
Running Water Source Line
It’s time to run your water line (tubing) from your water source to where your
1000 Pro Series will be place. For this section, you will require
1. Uncoil and run
A
1/4 in. White PP Tubing , from where its connected (to your water
source) to wherever you intend to locate your 1000 Pro Series. Make any necessary
adjustments (i.e. drilling holes) as you go.
2. Once you have the water line tubing ran all the way to where your 1000 Pro Series will
be placed, measure out a 1 - 2 ft. of additional tubing. You want to ensure you have
sufficient slack to pull the 1000 Pro Series away from the wall for maintenance.
3. Cut the tubing using your scissors or knife. Be careful to cut the tubing straight across (at
a 90 degree angle) to avoid leaks.
Diagram 2.4.3 Cut Tubing
4. Now, insert the open end of
A
1/4 in. White PP Tubing into one end (doesn’t matter
which) of
C
1/4 in. Quick Connect Shutoff Valve . Continue to firmly insert tubing
into opening until it won’t go any further. Then pull tubing backwards (away) from valve,
using medium force, to engage/extend the compression sleeve on the valve, and ensure
the connection is secured.