Drinkpod 1000 Pro Series, Installation Manual

Page: 13 / 67

Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series
2-11
Tapping Water Source
source
Option A: Tapping Accessory Water Line
In this section, you will require 1/4 in. White PP Tubing , and may also need
B
1/4 in. Compression To Quick Connect Adapter , and pliers, or an adjustable wrench or
1/2 in. wrench.
1. If nothing is currently connected to your water accessory line , skip forward to Step
#7 on page 2-14 .
2. If appliance is connected to water accessory line , start by powering off and
unplugging the appliance.
3. Pull the refrigerator (or other appliance) away from wall sufficiently to allow access to
wall and floor behind it.
Diagram 2.3A.3 Pulling Back Appliance To Access Water Source Line & Valve
4. In most scenarios, your shutoff valve and connection will look similar to the first diagram
below. We’ve also included the second and third most common setups in the proceeding
diagrams. The instructions should remain accurate, regardless of which setup yours is, as
long as it incorporates a shutoff valve. Should the latter not be the case, you will have to
locate the shutoff valve before proceeding.
A