Page 13
For technical questions, please call 1-800-444-3353.
SKU 94245
or clamp a straight edge to the material
to guide the saw on a straight path.
Refer to photo above.
Place the saw Base Plate on the material
6.
to be cut. Align the front notch (right
edge aligns with saw blade) on the cut
line.
Hold the Circular Saw by both handles.
7.
Always keep hands and fingers away
from the Saw Blade.
Push in and hold the Switch Lock Button,
8.
then squeeze the Switch (61) Trigger
with the index finger. Do this before the
saw blade touches the material.
With the saw at full speed, move the saw
9.
slowly forward to complete the cut.
When the cut is complete, release the
10.
Trigger. Do not set the saw down until
the blade stops turning.
To prevent accidents, turn off the tool
11.
and disconnect its power supply after
use. Clean, then store the tool indoors
out of children’s reach.
pocket Cuts
Tilt the saw forward with the cutting
1.
guide notch of the Base Plate on the line
drawn for the cut.
Raise the Blade Guard (20) with the
2.
Blade Guard Lever (35).
With the Saw Blade just above the
3.
material to be cut, start the saw and
allow the Saw Blade to come to full
speed.
Gradually lower the Saw Blade onto the
4.
stock using the front end of the Base
Plate as a pivot point.
When the cutting begins, release the
5.
Blade Guard.
When the Base Plate is resting flat on
6.
the stock being cut, proceed cutting in a
forward direction to the end of the cut.
When the cut is complete, release the
7.
Trigger and wait for the Saw Blade to
come to a stop before lifting the saw out
of the cut.
If necessary, complete the cut from the
8.
opposite direction in the same manner
described above.
WARNINg! Never pull the saw
backwards since the Saw Blade will
climb out of the cut and kickback will
occur.
When the cut is complete, release the
9.
Trigger. Do not set the saw down until
the blade stops turning.
To prevent accidents, turn off the tool
10.
and disconnect its power supply after
use. Clean, then store the tool indoors
out of children’s reach.
