Page 16
SKU 3733
For technical questions, please call 1-800-444-3353.
Fill the Body with water.
2.
cAuTIOn:
Make sure the water level is high
enough to cover the lower edge of
the Blade but
not
above the maxi-
mum water level as indicated by
the arrow.
nOTE:
3.
The Table may be tilted to
make
22.5
Degree or a
45
Degree
beveled cuts. To do so, extend the
two Legs (29) underneath the Table.
Place the legs into upper or lower
sections of the supports to achieve
the desired bevel.
Place the workpiece to be cut against
4.
the Rip Fence (7), and
slowly
feed
the workpiece into the Blade.
When finished making the beveled
5.
cut, turn the Power Switch to its OFF”
position and unplug the Power Cord
from its electrical outlet.
To Make Mitered Cuts:
To make a mitered cut, place the An-
1.
gle Gauge (21) against the Rip Fence
(7). Then position the workpiece
against the Angle Gauge, and
slowly
feed the workpiece into the Blade.
When finished making the angled cut,
2.
turn the Power Switch to its “OFF”
position and unplug the Power Cord
from its electrical outlet
MAInTEnAncE And
SERVIcIng
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
TO pREVEnT
SERIOuS InjuRY
FROM AccIdEnTAL
OpERATIOn:
Turn the power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO pREVEnT SERIOuS
InjuRY FROM TOOL
FAILuRE:
do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Pole
(29)
Table (1)
FIguRE 6
FIguRE 5
Pole (29)
Table (1)
