Owner's Manual Dri-Eaz TurboDryers®
115-V Model: Sahara Pro X3
READ AND SAVE THESE INSTRUCTIONS
A
WARNING
ELECTRIC SHOCK HAZARD
This unit must be electrically
grounded
The power cord is equipped with a
3-prong grounding plug. Use
only
with a matching receptacle.
Do not cut off the grounding prong.
Do not use an adapter.
Do not use with a damaged power
cord
Do not use an extension cord.
Read and understand manual be-
fore operating.
Use a 115V. 3-prong
.
Co not use with
grounded connection an adaptor
NOTE:
Hurnidity
will rise with the use of
TurboDryers, because they lift moisture
from wet materials into the air. To learn
about managing humidity during drying,
contact your local distributor or call Dri-
Eaz Education at 800-575-5152.
07-01537 Copyright 2006
Dri-Eaz Products, Inc,
Use and Operation
Dri-Eaz TurboDryers are high-performance airrnovers that promote
the evaporation of moisture from materials in order to speed the dry-
ing process. They are durable and easy to operate, utilizing an effec-
tive balance of static pressure and airflow.
PLACING YOUR TURBO DRYERS
When drying the interior of a building, use at least one TurboDryer
per water-damaged room, or one every 200 square feet. Try to get
airflow to all wet surfaces. Open interior doors to improve air circula-
tion, and brace doors to prevent them
from blowing
shut.
I
A WARNING I
Do not move or carry a TurboDryer while under operation. When the unit
is in motion, the powerful airflow is hard to control, and can produce
rapid and unpredictable movement.
Do not allow children to play with or around TurboDryers. If they lift or
get a unit off balance, the powerful airflow can cause the TurboDryer to
move rapidly, risking injury.
OPERATING YOUR TURBODRYER
1
Locate the electrical cord and plug into a standard 3-prong outlet
2 Set the switch to the desired speed. based on amp draw as fisted
by the switch on the side control panel.
THE AUXILIARY OUTLET
You can "daisy chain" or interconnect up to three Sahara Pro X3
units to customize your drying needs. The unit can conduct a
maximum of 12 amps when it is turned off or 8 amps when it is
turned on.
RED CIRCUIT BREAKER SWITCH
The primary purpose of the circuit breaker is to protect the machine. It
turns the unit off when more than 12 amps are run through the on-unit
circuit.
GROUND FAULT CIRCUIT INTERRUPTER
The GFCI protects the user. Should it detect a sudden "ground fault,"
the GFCI will interrupt the electric current. The GFCI will also trip
when a short circuit or overload occurs. If the GFCI "trips," unplug the
unit and look for potential hazards (standing water, frayed cord, etc.)
that might cause an electrical surge. Relocate the unit and plug into a
different outlet. Then push the "Reset" button and check to make
r., re. if
•1
•
•• "
Nr,"resti.-..-.
If
EN., nrsr,firki
n
4"
',nil n
Cn-, inedn