DRESSTA 32501, Operator'S Manual

Page: 120 / 177

SECTION 5
MAINTENANCE
Page 32
TD-15H DRESSTA
ENGINE
5.11.5. INSPECTION OF IDLER PULLEY
Idler pulley should be checked every 1000 hours of operation. The pulley should rotate freely but
without excessive play.
Fig. 5.21. Inspection of Idler Pulley
5.11.6. ETHER INJECTOR (if equipped)
Precautions
WARNING! Ether starting fluid is highly flammable.
Follow the precautions on the container. Explosion can result if sparks or flame
contact ether or a container is stored in temperature above 70 [°C].
Observe the following precautions:
•
Do not use the ether injector when air temperature is above 0 [°C].
•
Do not use open flame when using ether-starting fluid.
•
Do not store fluid containers in the operator's compartment.
•
Store containers in a cool, well ventilated place.
•
Keep fluid containers out of unauthorized personnel.
•
Do not breathe hazardous ether vapor.
•
Do not let ether contact your skin, because it can cause frostbite.
•
Never puncture a fluid container or put it into fire. Dispose of empty
containers properly.
•
For your safety, remove the ether container when welding, grinding, or using
a torch on a machine.
Follow the correct method of starting the engine. Refer to "STARTING THE ENGINE" in this
manual.
IMPORTANT: An ether starting valve inlet must be sealed against the entry of dirt at all times by
having a fluid container installed or by installing the dust cap provided with the valve.
https://www.truck-manuals.net/