Dresser Series D Installation Supplement
© 2019 Natural Gas Solutions North America, LLC
Page 19 of 24
Install the bottom set of screws and nuts as shown
in Figure 32.
After all three sets of screws and nuts are installed,
tighten each set.
Figure 32: Lower screws and nuts installed
After all hardware is tightened, install the red
tamper seals (supplied) on the Endpoint Module as
shown in Figure 33.
Figure 33: Attach top AMR mounting bracket
screws
9
Pulse Output Connections
This section provides information about connecting the pulse outputs with the meter and configuring
them with the Dresser MeterWare software.
Each Dresser Series D meter comes standard with two (2) flow frequency pulse outputs (Pulse Outputs 1
and 2) that represent volumetric information for remote data collection. Pulse Outputs 1 and 2 can be
configured for faults and alarm signals. Pulse Output 3 is reserved for fault and alarm signals only.
The pulse output cable is routed through a cable gland located at the back of the meter. The output
location is recessed and covered by a protective plate as shown in Figure 34.
Figure 34: Pulse output cable under the protective plate
