4
5
3.
Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at least 3 feet (0.9
m) from the front of the heater and keep them away from
the sides and rear.
4.
A heater has hot and arcing or sparking parts inside. Do
not use it in areas where gasoline, paint, or flammable
liquids are used or stored.
5.
To prevent a possible fire, do not block air intakes or
exhaust in any manner. Do not use on soft surfaces, like a
bed, where openings may become blocked.
6.
This heater is not intended for use in bathrooms, laundry
areas and similar indoor locations. Never locate heater
where it may fall into a bathtub or other water container.
ELECTRICITY SAFETY
1.
Always unplug heater when not in use.
2.
Do not operate any heater with a damaged cord or plug
or after the heater malfunctions, has been dropped or
damaged in any manner. Discard heater, or return to
authorized service facility for examination and/or repair.
3.
Do not run cord under carpeting. Do not cover cord with
throw rugs, runners, or similar coverings. Do not route cord
under furniture or appliances. Arrange cord away from
traffic area and where it will not be tripped over.
4.
To disconnect heater, turn controls to off, then remove
plug from outlet.
5.
Always plug heaters directly into a wall outlet/receptacle.
6.
Never use with an extension cord or relocatable power tap
(outlet/power strip).
7.
If there is a loose fit between the plug and the socket or
the plug becomes very hot, the socket may need to be
replaced. Check with a qualified electrician to replace the
socket.
8.
It is normal for the plug and cord to feel warm to the touch.
9.
A plug or cord which becomes hot to the touch or becomes
distorted in shape may be a result of a worn electrical
outlet. Worn outlets or receptacles should be replaced
prior to further use of the heater. Plugging the heater into
a worn outlet / receptacle may result in overheating of the
power cord or fire.
10.
This appliance has a polarized plug (one prong is wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician. Do not
attempt to rig this safety feature.
DANGER - High temperatures may be
generated under certain abnormal
conditions. Do not partially or fully cover
or obstruct the front of this heater.
READ AND SAVE
THESE INSTRUCTIONS
