26
27
TROUBLESHOOTING
5
ATTENTION
DO NOT unscrew
the unit.
DO NOT use
cleaning agents.
DO NOT use
abrasive scrubbers.
Fire or electrical shock hazard. DO
NOT immerse the main unit in water.
NEVER allow water to get inside the
heater.
Except for cleaning, any servicing
should be performed by an authorized
service representative.
Store in a cool, dry area and keep the
cable out of high-traffic areas to avoid
tripping hazards.
Correct Disposal of this product
This marking indicates that this product should not be disposed of with
other household waste throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources To
return your used device, please use the return and collection system or
contact the retailer where the product was purchased. They can take this
product for environmentally safe recycling.
English
English
Problem
Possible Causes
Solution
Malfunction
codes on LED
display
Heater does
not start
E2 - Temperature
sensor short circuit
E1 - Temperature
sensor open circuit
FF - Overheat
Protection
P4 - Tip-Over
Protection
Unplug it from the power
source and contact
Customer Support.
Unplug it from the power
source and contact
Customer Support.
Unplug and wait for it
to cool down before
plugging in again.
Place the heater back on
a flat, level and stable
surface.
Power cord is not
properly plugged in.
Overheat protection
has been activated.
Connect the plug to
a powered electrical
outlet.
Unplug and allow it to
cool.
Remove any objects on
or near the heater.
