1. COMMISSIONING
DANGER
Exceeding the maximum permitted torque
•
A setting above the maximum permitted torque is not permit-
ted.
DANGER
Regard the permitted torque range for additional gears, if
used
•
For actuators that are delivered with an additional gear or
thrust unit by the manufacturer, the permitted torque range is
written outside the housing cover.
1.2 Setting the limit positions
For setting the limit positions for OPEN and CLOSE, use the setting screws as shown in
figure 1.2.
1. Setting screw for limit position
OPEN
2. Setting screw for limit position
CLOSED
Figure 1.2: Limit switches in standard version
For setting a limit position, operate the actuators into the desired position. Press the screw
downward by means of the screwdriver and turn in direction of the arrow. The limit posi-
tion is set when the cam operates the appropriate limit switch. After the setting procedure,
release the screw.
Setting screws for limit positions engage in short intervals while being turned. Once cam
Additional operating manual
5
