Sapporo Sleepmotion Lifestyle TV Bed - Assembly guide - Page 10
9
h
x2
j
IF HARDWARE IS SUPPLIED WITH THE TV, PLEASE USE IT IN PREFERENCE
Fitting the TV.
Check the hardware supplied with
television and if Vesa screws and spacers
are supplied please use these to fit the TV.
i)
iii)
iv)
To adjust the two TV supports (k), stand the
television in position and loosely secure it to
the TV mounting bracket (x) using the
hardware supplied. Each slider should be set
to just touch the front bezel. To make sliding
each support easier, lift the TV slightly,
above the support being adjusted.
Once supports are set,
lightly push down In the
centre of the TV and
tighten the two Vesa
bolts 100%, these should
be in the centre of the
long holes as shown.
ii)
When spacers are provided it is very
important that these are fitted in the
correct place, fit between television
& the TV mounting bracket (x) as in
this sketch. The spacers are needed
to keep the TV screen vertical.
TV
TV BRACKET (x)
(x)
h
j
Bolt sets
(M8 x 25mm)
Countersunk screw
sets (M6x12mm).
Countersunk screw
sets (M 4 x12mm).
Allen Key (4mm).
Allen Key (2.5mm).
If hardware is not supplied
with the TV, choose suitable
fittings from the TV Kit
